The Aftermarket Industries billet Fuel Pump Power Bulkhead Terminal (Design Protected) is designed specifically for anyone who is considering upgrading or has upgraded their OEM fuel pump to an aftermarket performance fuel pump (Walbro 255, Walbro 460, Walbro 520 etc). The fact is an OEM electrical connector will NOT support the current & amperage requirements of these aftermarket pumps with most connectors rated at 7.5A; a single Walbro 460, depending on whether it is being used a surge-tank-supply pre pump or as the stand-alone supply pump, will draw 12A at the very least (less than 40psi fuel pressure) and up to 21A under high pressure (80psi+)
Simply cut a hole (26-28mm), insert the Power Terminal, secure both ends and connect your wires; he o-ring has a burst seal strength well beyond 350psi and Aftermarket Industries guarantee of ZERO vapour loss.
Amperage Capability: 85A per stud
Dimensions: 33mm OD, 38.65 (Height with studs based on 2mm plate), 18.57mm (height of body based on 2mm plate)
Package Includes: Requires Assembly (estimated assembly time 5 minutes)
1 & 2. Power Terminal (Upper - 6061-T6 billet anodised in black)
3. Viton O-ring
4. Stainless Steel Power Studs (Upper M5/Lower M4)
5. 4x Solid Copper (Tinned) Eyelets (Current Rating: 66A per Eyelet)
Add a Motorsport (Mil-Spec) Power (Wiring) Distribution Kit to Your Order: Fuel pump wiring is one of the most neglected and misunderstood aspects of any performance fuel system upgrade. It's also one of the leading causes of fuel pump failure including engine failure due to incorrectly sized electrical components resulting in fuel pumps that simply won't flow due to resistance.
Aftermarket Industries has removed ALL the complexity from the process: We GUARANTEE that this package will meet your requirements or your MONEY BACK! Best of all, we ONLY use premium products and brands manufactured by brands. Includes the following: (requires cut & crimp)